|DroboPro support, unmount volume, not device
|Page 1 of 1|
|Author:||ptr727 [ Fri Dec 18, 2009 4:27 pm ]|
|Post subject:||DroboPro support, unmount volume, not device|
Hi, I just installed a DroboPro storage device.
I created two volumes on the drobo, and they show up as two drives in windows.
I want to power cycle the drobo to apply a configuration change, but I have to unmount the drives to prevent data corruption.
Problem is that the drobo dashboard application keeps the USB device open, and the unmount fails.
This is a catch-22, the drobo dashboard uses USB to communicate to the drobo device, the dashboard uses USB to instruct a power cycle, if I disconnect USB, then I loose control connectivity.
The alternative is to power down the PC, and manually power cycle the drobo, I want to avoid that hassle.
I want safely remove to unmount the drives, but not the USB device.
How can I do this?
|Page 1 of 1||All times are UTC|
|Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group