Re-enable a USB device after a "Safely remove hardware"

Post Reply
TKB
Posts: 2
Joined: Mar 30th, 2009, 8:31 am

Re-enable a USB device after a "Safely remove hardware"

Post by TKB » Mar 30th, 2009, 8:34 am

Hello everyone.

What is the command to re-enable a USB device after a "Safely remove hardware" without rebooting or disconnect/reconnect the USB plug?

Thank you in advance for your help.
User avatar
Igor
Developer
Posts: 562
Joined: Nov 1st, 2007, 12:44 pm
Location: Saint Petersburg
Contact:

Re: Re-enable a USB device after a "Safely remove hardware"

Post by Igor » Mar 30th, 2009, 2:39 pm

TKB wrote:Hello everyone.

What is the command to re-enable a USB device after a "Safely remove hardware" without rebooting or disconnect/reconnect the USB plug?

Thank you in advance for your help.
Hi TKB,

If you ask how to do it in USB Safely Remove, it's easy: After you stopped a device in USB Safely Remove it became red-crossed, just left click on the device again and it will be re-enabled.

Image[/img]
TKB
Posts: 2
Joined: Mar 30th, 2009, 8:31 am

Re: Re-enable a USB device after a "Safely remove hardware"

Post by TKB » Mar 30th, 2009, 4:01 pm

Ok. I'll give it a try.

Thank you once more for your help.

Igor wrote:
TKB wrote:Hello everyone.

What is the command to re-enable a USB device after a "Safely remove hardware" without rebooting or disconnect/reconnect the USB plug?

Thank you in advance for your help.
Hi TKB,

If you ask how to do it in USB Safely Remove, it's easy: After you stopped a device in USB Safely Remove it became red-crossed, just left click on the device again and it will be re-enabled.

Image[/img]
Post Reply